<#import "/templates/guide.adoc" as tmpl> <#import "/templates/links.adoc" as links> <@tmpl.guide title="Fail over to the secondary site" summary="This describes the automatic and operational procedures necessary" preview="true" > This {section} describes the steps to fail over from primary site to secondary site in a setup as outlined in <@links.ha id="concepts-active-passive-sync" /> together with the blueprints outlined in <@links.ha id="bblocks-active-passive-sync" />. == When to use procedure A failover from the primary site to the secondary site will happen automatically based on the checks configured in the loadbalancer. When the primary site loses its state in {jdgserver_name} or a network partition occurs that prevents the synchronization, manual procedures are necessary to recover the primary site before it can handle traffic again, see the <@links.ha id="operate-switch-back" /> {section}. To prevent an automatic fallback to the primary site before those manual steps have been performed, configure the loadbalancer as described following to prevent this from happening automatically. For a graceful switch to the secondary site, follow the instructions in the <@links.ha id="operate-switch-over" /> {section}. See the <@links.ha id="introduction" /> {section} for different operational procedures. == Procedure Follow these steps to manually force a failover. === Route53 To force Route53 to mark the primary site as permanently not available and prevent an automatic fallback, edit the health check in AWS to point to a non-existent route (`health/down`).