keycloak-scim/server_installation/topics/network/bind-address.adoc

[[_bind-address]]

=== Bind addresses

By default {project_name} binds to the localhost loopback address `127.0.0.1`.  That's not a very useful default if
you want the authentication server available on your network.  Generally, what we recommend is that you deploy a reverse proxy
or load balancer on a public network and route traffic to individual {project_name} server instances on a private network.
In either case though, you still need to set up your network interfaces to bind to something other than `localhost`.

Setting the bind address is quite easy and can be done on the command line with either the _standalone.sh_ or
_domain.sh_ boot scripts discussed in the <<_operating-mode, Choosing an Operating Mode>> chapter.

[source]
----
$ standalone.sh -b 192.168.0.5
----

The `-b` switch sets the IP bind address for any public interfaces.

Alternatively, if you don't want to set the bind address at the command line, you can edit the profile configuration of your deployment.
Open up the profile configuration file (_standalone.xml_ or _domain.xml_ depending on your
<<_operating-mode, operating mode>>) and look for the `interfaces` XML block.

[source,xml]
----
    <interfaces>
        <interface name="management">
            <inet-address value="${jboss.bind.address.management:127.0.0.1}"/>
        </interface>
        <interface name="public">
            <inet-address value="${jboss.bind.address:127.0.0.1}"/>
        </interface>
    </interfaces>
----

The `public` interface corresponds to subsystems creating sockets that are available publicly.  An example of one
of these subsystems is the web layer which serves up the authentication endpoints of {project_name}.  The `management`
interface corresponds to sockets opened up by the management layer of the {appserver_name}.  Specifically the sockets
which allow you to use the `jboss-cli.sh` command line interface and the {appserver_name} web console.

In looking at the `public` interface you see that it has a special string `${jboss.bind.address:127.0.0.1}`.  This string
denotes a value `127.0.0.1` that can be overridden on the command line by setting a Java system property, i.e.:

[source]
----
$ domain.sh -Djboss.bind.address=192.168.0.5
----

The `-b` is just a shorthand notation for this command.  So, you can either change the bind address value directly in the profile config, or change it on the command line when
you boot up.

NOTE:  There are many more options available when setting up `interface` definitions. For more information, see link:{appserver_network_link}[the network interface] in the _{appserver_network_name}_.